Microsoft virtual pc 2007 mouse not working

TechNet - Where is the Forum For…? Please let us know the results and if you need further assistance. How satisfied are you with this reply?

Thanks for your feedback, it helps us improve the site. Andre Da Costa Volunteer Moderator. This action will open Turn Windows features on or off. Once it has loaded all the features, check off all the options for Hyper-V and click OK. Then wait while Windows installs and configures Hyper-V. You will be prompted to restart to confirm changes.

Windows will go through a series of restarts and configure your system. In the left pane of the Hyper-V Manager, select your machine name.

This selection will enable the actions pane on the right. This will start the Create New Virtual Machine wizard. Click Next and follow the on-screen instructions. I can give my Virtual Machine a name and specify its location where I want it stored.

So if you have additional partitions or a drive, then you can browse and save it there. Choose the type of generation you would prefer to use. If you are basing your needs around legacy or older applications, go with Generation 1.

Choose how much memory you would like to give the virtual machine. This choice will be dependent on how much you have available. The more, the better. For my purposes, I will be doing application testing, so this should be enough for the operating system in addition to the applications I will be testing.

If you see a similar screen shown below, click Next to continue. You can always configure your Network settings after. Configure your Virtual Hard disk where you will install the operating system. You can make quick changes here such as the location where it will be stored along with the amount space you would like to give the Virtual machine. Here you can see — I have given the virtual machine 5 GBs of disk space.

You can also choose an existing Virtual hard disk if you already have one. Rebooted VM again. If I go into settings they are set to auto-enable, however on Tools, Enable Integration Components is disabled. Get a message that Integration components can't be started, but that you can continue without them. The integration features work correctly in that VM, so it makes me think that externally i.

Win7 setup everything is OK. Same problem. Friday, November 20, PM. Can you check the following: 1. Is Remote Desktop enabled in Remote connection Settings. Is remote desktop allowed in firewall exception list? You can verify the above two by trying to TS into the vm. Is port open? You can continue the reading to update some components, especially if you actually use Windows 8. By starting any virtual machine, you eventually get that BSOD! This is definitely the problem.

To save your bandwidth, here is a much smaller archive Kb with the revised driver: Download the updated vmm. Obviously, you have to use the file intended for your system; you cannot use a bit driver on a bit system or the opposite!

In case of mistake, Microsoft Virtual PC no longer runs. To repair, replace the wrong version by the correct one; that may imply starting the computer into safe mode. It's even possible to run them simultaneously. The next screenshot proves it: you haven't to choose between these two pieces of software.

You can enjoy the one without giving up the other! Because that hotfix replaces the original vmm. Consequently, that fix doesn't apply to that operating system. If you upgrade vmm. Please note you may have to rename the executable file again after applying the Rollup. The installation of Rollup is normally done on Windows 8. Specific problems of Windows 8.

However, there are additional problems with some pieces of software, including Microsoft Virtual PC Luckily, there are solutions! Important: Windows 8. Installation It's basically the same as Windows 8. See the above « procedure ».